DEK-OE- 5DC/ 5DC/100KHZ-G - Solid-state relay terminal block

2964542

Input solid-state relay, with DC voltage output push-pull, transmission frequency: 100 kHz, with light indicator and protective circuit in input and output circuits, input: 5 V DC, output: 4 - 18 V DC/50 mA

Note on application Use of EB 80-DIK... bridges in the DEK terminal blocks: Absorption of humidity from the ambient air as well as an unfavorable tolerance between a larger number of DEK terminal blocks and the EB 80-DIK... bridge may cause (minor) expansion of the DEK housing. When the EB 80-DIK... bridges are used, therefore, it is recommended that these be disconnected after about 10 to 12 DEK terminal blocks and a wire bridge to the next DEK terminal block be inserted in their place.

Product type Solid-state relay module
Product family DEK
Application 100 kHz input optocoupler
Operating mode 100% operating factor
Insulation characteristics
Insulation Basic insulation
Insulation characteristics
Insulation Basic insulation
Overvoltage category II
Pollution degree 2

Test voltage (Input/output) 2.5 kV AC (Input/output)

Nominal input voltage UN 5 V DC
Input voltage range in reference to UN 0.5 ... 1.2
Input voltage range 2.5 V DC ... 6 V DC
Switching threshold "0" signal in reference to UN ≤ 0.3
Switching threshold "1" signal in reference to UN ≥ 0.5
Typical input current at UN 8 mA
Typical response time 1 µs
Typical turn-off time 2 µs
Operating voltage display Yellow LED
Protective circuit Reverse polarity protection; Polarity protection diode
Surge protection
Transmission frequency 100 kHz

Contact switching type 1 N/O contact
Design of digital output electronic
Output voltage range 4 V DC ... 18 V DC
Limiting continuous current 50 mA
Quiescent current 8.5 mA
Voltage drop at max. limiting continuous current ≤ 1.2 V DC
Output circuit 3-conductor push-pull, ground referenced
Protective circuit Surge protection; Suppressor diode

Connection method Screw connection
Stripping length 8 mm
Screw thread M3
Conductor cross section rigid 0.2 mm² ... 2.5 mm²
Conductor cross section flexible 0.2 mm² ... 2.5 mm²
Conductor cross section AWG 24 ... 14
Tightening torque 0.5 Nm

Width 6.2 mm
Height 80 mm
Depth 56 mm

Color green (RAL 6021)

Ambient conditions
Ambient temperature (operation) -20 °C ... 60 °C
Ambient temperature (storage/transport) -20 °C ... 70 °C

Standards/regulations IEC 60947-5-1

Mounting type DIN rail mounting
Assembly instructions in rows with zero spacing
Mounting position any