DEK-OV- 24DC/ 24DC/ 10 - Solid-state relay terminal block

2964322

Power solid-state relay terminal block with short-circuit-proof DC voltage output, input: 24 V DC, output: 3 - 33 V DC/10 A

Order information: The housing is open on one side. The appropriate cover is D-DEK 1,5 GN (2716949).
Note on application Use of EB 80-DIK... bridges in the DEK terminal blocks: Absorption of humidity from the ambient air as well as an unfavorable tolerance between a larger number of DEK terminal blocks and the EB 80-DIK... bridge may cause (minor) expansion of the DEK housing. When the EB 80-DIK... bridges are used, therefore, it is recommended that these be disconnected after about 10 to 12 DEK terminal blocks and a wire bridge to the next DEK terminal block be inserted in their place.

Product type Solid-state relay module
Product family DEK
Application Output function
Operating mode 100% operating factor
Insulation characteristics
Insulation Basic insulation
Insulation characteristics: Air clearances and creepage distances between the power circuits
Insulation Basic insulation
Overvoltage category II
Pollution degree 2

Maximum power dissipation for nominal condition 0.5 W
Test voltage (Input/output) 2.5 kV AC (Input/output)
Air clearances and creepage distances between the power circuits
Rated insulation voltage 50 V DC
Rated surge voltage 0.5 kV

Nominal input voltage UN 24 V DC
Input voltage range in reference to UN 0.8 ... 1.2
Input voltage range 19.2 V DC ... 28.8 V DC
Switching threshold "0" signal in reference to UN ≤ 0.4
Switching threshold "1" signal in reference to UN ≥ 0.8
Typical input current at UN 3.5 mA
Typical response time 100 µs
Typical turn-off time 500 µs
Operating voltage display Yellow LED
Protective circuit Reverse polarity protection
Surge protection
Transmission frequency 100 Hz

Contact switching type 1 N/O contact
Design of digital output electronic
Output voltage range 8 V DC ... 33 V DC
Limiting continuous current 10 A (see derating curve)
Surge current 100 A (t = 20 ms)
Voltage drop at max. limiting continuous current ≤ 50 mV
Output circuit 3-conductor, ground-referenced
Protective circuit Reverse polarity protection
Surge protection

Connection method Screw connection
Stripping length 8 mm
Screw thread M3
Conductor cross section rigid 0.2 mm² ... 2.5 mm²
Conductor cross section flexible 0.2 mm² ... 2.5 mm²
Conductor cross section AWG 24 ... 14
Tightening torque 0.5 Nm

Width 6.2 mm
Height 80 mm
Depth 56 mm

Color green (RAL 6021)

Ambient conditions
Ambient temperature (operation) -20 °C ... 60 °C
Ambient temperature (storage/transport) -20 °C ... 70 °C
Altitude ≤ 2000 m

Air clearances and creepage distances between the power circuits
Standards/regulations DIN EN 60947-5-1