IL S3 BK DI8 DO4 2TX-PAC - Bus coupler

2692380

Inline, Bus coupler, Sercos, RJ45 jack, Digital inputs: 8, 24 V DC, connection technology: 3-conductor, Digital outputs: 4, 24 V DC, 500 mA, connection technology: 3-conductor, transmission speed in the local bus: 500 kbps / 2 Mbps, degree of protection: IP20, including inline connectors, marking fields, and end plate

The bus coupler with integrated I/Os is intended for use within a Sercos® network and represents the link to the Inline I/O system. Up to 63 Inline devices can be connected to the bus coupler. The bus coupler supports a maximum of 16 PCP devices. A corresponding SDDML file is available for integrating the Inline station into the programming system. This file can be downloaded at: phoenixcontact.net/product/2692380.

Dimensional drawing
Width 80 mm
Height 119.8 mm
Depth 71.5 mm
Note on dimensions Specfications with connectors

Sercos
Number of interfaces 2
Connection method RJ45 jack
Inline local bus
Number of interfaces 1
Connection method Inline data jumper
Transmission speed 500 kbps / 2 Mbps (automatic detection, no combined system)
Sercos
Equipment type Sercos slave

System limits
Number of supported devices max. 63 (per station)
Number of local bus devices that can be connected max. 63
Number of devices with parameter channel max. 16
Number of supported branch terminals with remote bus branch 0
Module
ID code (hex) none

Digital:
Input name Digital inputs
Description of the input EN 61131-2 type 1
Number of inputs 8
Connection method Inline connector
Connection technology 3-conductor
Input voltage 24 V DC
Input voltage range "0" signal -30 V DC ... 5 V DC
Input voltage range "1" signal 15 V DC ... 30 V DC
Nominal input voltage UIN 24 V DC
Nominal input current at UIN typ. 3 mA
Typical input current per channel typ. 3 mA
Typical response time approx. 500 µs
Protective circuit Reverse polarity protection; Suppressor diode

Digital:
Output name Digital outputs
Connection method Inline connector
Connection technology 3-conductor
Number of outputs 4
Protective circuit Short-circuit and overload protection; Freewheeling circuit in the output driver
Output voltage 24 V DC -1 V (At nominal current)
Maximum output current per module max. 2 A
Nominal output voltage 24 V DC
Output voltage when switched off max. 500 mV
Output current when switched off max. 500 µA (When not loaded, a voltage can be measured even at an output that is not set.)
Nominal load, inductive 12 VA (1.2 H, 48 Ω)
Nominal load, lamp 12 W
Nominal load, ohmic 12 W
Reverse voltage resistance to short pulses Reverse voltage proof
Behavior with overload Auto restart
Behavior with inductive overload Output can be destroyed
Behavior at voltage switch-off The output follows the power supply without delay
Signal delay < 40 µs (ton, no load)
< 50 µs (ton, load = 0.5 A)
< 350 µs (toff, no load)
< 235 µs (toff, load = 0.5 A)
Overcurrent shut-down min. 0.7 A
Output current with ground connection interrupt when switched off max. 25 mA

Product type I/O component
Product family Inline
Type modular
Scope of delivery including inline connectors, marking fields, and end plate
No. of channels 12
Diagnostics messages Short-circuit or overload of the digital outputs yes
Sensor supply failure yes
Failure of the actuator supply yes