SACC-M 8MR-3CON-M-SW - Connector

1407583

Connector, Universal, 3-position, Plug angled M8, coding: A, Screw connection, knurl material: Brass, nickel-plated, external cable diameter 3.5 mm ... 5 mm

Assembly instruction: NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Assembly instructions The wires can be connected both with ferrules (without insulation) and without ferrules.
The connector pin assignment can be rotated 180° to the cable outlet

Product type Circular connector (cable-side)
Sensor type Universal
Number of positions 3
No. of cable outlets 1
Shielded no
Coding A
Cable outlet angled
Insulation characteristics
Overvoltage category III
Degree of pollution 3

Dimensional drawing
Width 13 mm
Height 32.5 mm
Length 46 mm
External dimensions
Outside diameter 3.5 mm ... 5 mm
Housing
Diameter housing 13 mm

Flammability rating according to UL 94 HB
Seal material NBR
Material of grip body PBT
Contact material CuZn
Contact surface material Au
Contact carrier material PA
Material for screw connection Brass, nickel-plated

Conductor connection
Connection method Screw connection
Connection cross section 0.14 mm² ... 0.5 mm² (without ferrule)
0.14 mm² ... 0.5 mm² (with ferrule)
0.14 mm² ... 0.5 mm² (solid)
Connection cross section AWG 26 ... 20 (without ferrule)
Stripping length of the individual wire 4 mm
Tightening torque 0.2 Nm (M8 knurl)
0.5 Nm (Connector with coupling sleeve)
0.3 Nm ... 0.4 Nm (Pressure screw for outer cable diameter 3 mm ... 4 mm)
0.8 Nm ... 1 Nm (Pressure screw in the case of external cable diameter 4 mm ... 5 mm)
0.1 Nm (Screw terminal blocks)

Rated surge voltage 1.5 kV
Contact resistance ≤ 3 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 4 A