SACC-M12MS-5CON-PG7-M SKIN - Connector

1456466

Sensor/actuator connector, straight, 5-pos., M12, A-coded, screw connection, metal knurl, cable gland Pg7 SKINTOP®

Assembly instruction: NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Product type Circular connector (cable-side)
Sensor type Universal
Number of positions 5
No. of cable outlets 1
Shielded no
Coding A
Pg screw connection Pg7
Insulation characteristics
Overvoltage category II
Degree of pollution 3

Dimensional drawing
Width 20.2 mm
Height 20.2 mm
Length 76 mm
External dimensions
Outside diameter 4 mm ... 6 mm
Housing
Diameter housing 20.2 mm

Flammability rating according to UL 94 HB
Seal material NBR
Material of grip body PBT
Contact material CuZn
Contact surface material CuSnZn
Contact carrier material PA
Material for screw connection Zinc die-cast, nickel-plated

Conductor connection
Connection method Screw connection
Connection cross section 0.25 mm² ... 0.75 mm² (without ferrule)
0.14 mm² ... 0.75 mm² (with ferrule)
0.25 mm² ... 0.75 mm² (solid)
Connection cross section AWG 24 ... 18 (without ferrule)
26 ... 20 (with ferrule)
Stripping length of the individual wire 5 mm
Tightening torque 0.4 Nm (M12 knurl)
0.2 Nm (Screw terminal blocks)
0.8 Nm ... 1 Nm (Pressure screw)

Rated surge voltage 1.5 kV
Contact resistance ≤ 8 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 4 A

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Plug
Head cable outlet straight
Head thread type M12
Coding A

Signal type/category Universal
Stripping length of the individual wire 5 mm

Ambient conditions
Degree of protection IP67
Ambient temperature (operation) -20 °C ... 80 °C (Plug / socket)

M12
Standard designation M12 connector
Standards/specifications IEC 61076-2-101