SACC-M 8MS-3CON-M-SW - Connector

1501252

Connector, Universal, 3-position, Plug straight M8, coding: A, Screw connection, knurl material: Brass, nickel-plated, external cable diameter 3.5 mm ... 5 mm

Assembly instruction: NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Assembly instructions The wires can be connected both with ferrules (without insulation) and without ferrules.

Product type Circular connector (cable-side)
Sensor type Universal
Number of positions 3
No. of cable outlets 1
Shielded no
Coding A
Insulation characteristics
Overvoltage category III
Degree of pollution 3

Dimensional drawing
Width 12 mm
Height 12 mm
Length 50 mm
External dimensions
Outside diameter 3.5 mm ... 5 mm
Housing
Diameter housing 12 mm

Flammability rating according to UL 94 HB
Seal material NBR
Material of grip body PBT
Contact material CuZn
Contact surface material Au
Contact carrier material PA
Material for screw connection Brass, nickel-plated

Conductor connection
Connection method Screw connection
Connection cross section 0.14 mm² ... 0.5 mm² (without ferrule)
0.08 mm² ... 0.5 mm² (with ferrule)
0.14 mm² ... 0.5 mm² (solid)
Connection cross section AWG 26 ... 20 (without ferrule)
Stripping length of the individual wire 4 mm
Tightening torque 0.2 Nm (M8 knurl)
0.5 Nm (Connector with coupling sleeve)
0.3 Nm ... 0.4 Nm (Pressure screw for outer cable diameter 3 mm ... 4 mm)
0.8 Nm ... 1 Nm (Pressure screw in the case of external cable diameter 4 mm ... 5 mm)
0.1 Nm (Screw terminal blocks)

Rated surge voltage 1.5 kV
Contact resistance ≤ 3 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 4 A

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Plug
Head cable outlet straight
Head thread type M8
Coding A

Signal type/category Universal
Stripping length of the individual wire 4 mm