SACC-M12FSB-5CON-PG9 SH AU - Data connector

1507777

Data connector, PROFIBUS, INTERBUS, 5-position, shielded, Socket straight M12, coding: B, Screw connection, knurl material: Zinc die-cast, nickel-plated, cable gland Pg9, external cable diameter 6.5 mm ... 8.5 mm

Assembly instruction: NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Product type Circular connector (cable-side)
Application Data
Sensor type PROFIBUS
Number of positions 5
No. of cable outlets 1
Shielded yes
Coding B
Cable outlet straight
Pg screw connection Pg9
Insulation characteristics
Overvoltage category II
Degree of pollution 3

Dimensional drawing
Width 20 mm
Height 20 mm
Length 56 mm
External dimensions
Outside diameter 6.5 mm ... 8.5 mm
Housing
Diameter housing 20 mm

Flammability rating according to UL 94 HB
Seal material NBR
Material of grip body Zinc die-cast, nickel-plated
Contact material CuZn
Contact surface material Au
Contact carrier material PA 6.6
Material for screw connection Zinc die-cast, nickel-plated

Conductor connection
Connection method Screw connection
Connection cross section 0.25 mm² ... 0.75 mm² (without ferrule)
0.14 mm² ... 0.75 mm² (with ferrule)
0.25 mm² ... 0.75 mm² (solid)
Connection cross section AWG 24 ... 18 (without ferrule)
26 ... 20 (with ferrule)
Stripping length of the individual wire 5 mm
Tightening torque 0.4 Nm (M12 knurl)
0.2 Nm (Screw terminal blocks)
0.8 Nm ... 1 Nm (Pressure nut with 4 mm ... 8 mm external cable diameter)
1 Nm ... 1.4 Nm (Pressure nut with 8 mm ... 12 mm external cable diameter)

Rated surge voltage 1.5 kV
Contact resistance ≤ 3 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 4 A

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Socket
Head cable outlet straight
Head thread type M12
Coding B