PLC-OPT- 24DC/ 24DC/10/R - Solid-state relay module

2900398

PLC-INTERFACE with confirmation contact, consisting of basic terminal block with push-in connection and integrated miniature solid-state relay, for mounting on DIN rail NS 35/7,5, 1 N/O contact, input: 24 V DC, output: 3 - 33 V DC/10 A

Notes on operation The PLC-ATP partition plate must be installed for voltages greater than 250 V (L1, L2, L3) between identical terminal blocks on adjacent modules.
Notes on operation The PLC-ATP separating plate should be installed for safe isolation between adjacent modules
Notes on operation Do not connect adjacent channels to SELV/ PELV and voltages dangerous to the touch.
Notes on operation The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
Notes on operation At least one functional insulation against adjacent modules is complied with in the support rail direction.
If the application has higher requirements on the insulation (basic or reinforced insulation), then these must be realized through suitable measures (e. g., partition plates).
Notes on operation Do not use to separate SELV / PELV circuits from other circuits, because safe isolation is not guaranteed.

Product type Solid-state relay module
Product family PLC-INTERFACE
Application With integrated solid-state relay
Operating mode 100% operating factor
Insulation characteristics
Insulation Basic insulation
Insulation characteristics: Air clearances and creepage distances between the power circuits
Insulation Basic insulation
Overvoltage category II
Pollution degree 2

Maximum power dissipation for nominal condition 0.07 W
Air clearances and creepage distances between the power circuits
Rated insulation voltage 50 V DC
Rated surge voltage 0.5 kV

Rated actuating voltage UC 24 V DC
Rated actuating current IC 3.5 mA
Switching threshold "0" signal in reference to UN < 0.4
Switching threshold "1" signal in reference to UN > 0.8
Typical response time 100 µs
Typical turn-off time 500 µs
Operating voltage display Yellow LED
Protective circuit Reverse polarity protection; Polarity protection diode
Surge protection
Surge voltage protection > 33 V
Transmission frequency 100 Hz

Designation DC voltage output
Contact switching type 1 N/O contact
Design of digital output electronic
Contact connection type Power contact
Output voltage range 8 V DC ... 33 V DC
Limiting continuous current 10 A (see derating curve)
Quiescent current 5.2 mA
Voltage drop at max. limiting continuous current < 50 mV
Output circuit 3-conductor, ground-referenced
Protective circuit Inverse diode
Surge protection
Designation Alarm output
Output voltage range 3 V DC ... 33 V DC
Limiting continuous current 100 mA
Surge voltage protection > 33 V
Voltage drop at max. limiting continuous current < 1.2 V
Output circuit 2-conductor, floating
Error indication Red LED
Protective circuit Reverse polarity protection; Polarity protection diode
Surge protection; Suppressor diode

Connection method Push-in connection
Stripping length 10 mm
Conductor cross section rigid 0.14 mm² ... 2.5 mm²
Conductor cross section flexible 0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1 mm² (TWIN ferrule)
Conductor cross section AWG 26 ... 14