SACC-M12MS-4CON-PG9-M - Connector

1523230

Connector, 4-position, Plug straight M12, coding: A, Screw connection, knurl material: Zinc die-cast, nickel-plated, cable gland Pg9, external cable diameter 6 mm ... 8 mm

Assembly instruction: NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Product type Circular connector (cable-side)
Number of positions 4
No. of cable outlets 1
Shielded no
Coding A
Cable outlet straight
Pg screw connection Pg9
Insulation characteristics
Overvoltage category II
Degree of pollution 3

Dimensional drawing
Length 60 mm
External dimensions
Outside diameter 6 mm ... 8 mm
Housing
Diameter housing 20 mm

Flammability rating according to UL 94 HB
Seal material NBR
Material of grip body PA
Contact material CuZn
Contact surface material CuSnZn
Contact carrier material PA
Material for screw connection Zinc die-cast, nickel-plated

Conductor connection
Connection method Screw connection
Connection cross section 0.25 mm² ... 0.75 mm² (without ferrule)
0.14 mm² ... 0.75 mm² (with ferrule)
0.25 mm² ... 0.75 mm² (solid)
Connection cross section AWG 24 ... 18 (without ferrule)
26 ... 20 (with ferrule)
Stripping length of the individual wire 5 mm
Tightening torque 0.4 Nm (M12 knurl)
0.8 Nm ... 1 Nm (Pressure screw with sleeve housing)
0.2 Nm (Screw terminal blocks)

Rated surge voltage 2.5 kV
Contact resistance ≤ 8 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 250 V AC
250 V DC
Nominal current IN 4 A

Mechanical data
Insertion/withdrawal cycles ≥ 50

Connection 1
Head design Plug
Head cable outlet straight
Head thread type M12
Coding A

Stripping length of the individual wire 5 mm

Ambient conditions
Degree of protection IP67
Ambient temperature (operation) -40 °C ... 85 °C (Plug / socket)

Standard designation M12 connector
Standards/specifications IEC 61076-2-101