IB IL PWM/2-PAC - Function module

2861632

Inline function terminal for pulse width and frequency modulation or activation of impulse-driven motor control parts with pulse/direction interface, two outputs for 5 V or 24 V

The terminal is designed for use within an Inline station. Two channels that operate independently of one another offer the option of pulse width modulation (PWM) for the output signals. The terminal block supports the following operating modes: PWM (pulse width modulation), frequency generator, single shot (single pulse generator), and pulse direction signal.

Dimensional drawing
Width 24.4 mm
Height 136.8 mm
Depth 71.5 mm

Inline local bus
Number of interfaces 2
Connection method Inline data jumper
Transmission speed 500 kbps

Module
ID code (dec.) 191
ID code (hex) BF
Length code (hex) 02
Length code (dec) 02
Process data channel 32 bit
Input address area 4 Byte
Output address area 4 Byte
Register length 4 Byte
Required parameter data 1 Byte
Required configuration data 5 Byte

Digital:
Output name Digital output: 24 V DC
Connection technology 2-conductor (shielded)
Number of outputs 2
Protective circuit Short-circuit protection, overload protection of the outputs; integrated damping diode for each channel
Output voltage 24 V
Maximum output current per module / terminal block 1 A
Nominal output voltage 24 V DC
Nominal load, inductive 12 VA (1.2 H, 24 Ω)
Nominal load, lamp 12 W
Nominal load, ohmic 12 W
Maximum operating frequency with ohmic nominal load 500 Hz
Reverse voltage resistance to short pulses Reverse voltage proof
Behavior with overload Auto restart
Behavior at voltage switch-off The output follows the power supply without delay
Overcurrent shut-down as of 0.7 A
Digital:
Output name Digital output: 5 V DC
Connection technology 2-conductor (shielded)
Number of outputs 2
Protective circuit Short-circuit protection, overload protection of the outputs; integrated damping diode for each channel
Nominal output voltage 5 V DC
Maximum operating frequency with ohmic nominal load 50 kHz

Product type I/O component
Product family Inline
Type modular
Operating mode PWM, frequency generator, single-shot, pulse/direction signal
Process data operation with 2 words
Diagnostics messages Short circuit or overload of a 24 V output yes

Potentials: Communications power (UL)
Supply voltage 7.5 V DC (via voltage jumper)
Current draw max. 130 mA
Power consumption max. 0.98 W
Potentials: Segment circuit supply (US)
Supply voltage 24 V DC (via voltage jumper)
Current draw max. 1 A
0 A
Electrical isolation/isolation of the voltage ranges
Test voltage: 7.5 V supply (bus logics)/24 V supply (I/O) 500 V AC, 50 Hz, 1 min.
Test voltage: 7.5 V supply (bus logic) / 5 V supply (I/O) 500 V AC, 50 Hz, 1 min.
Test voltage: 24 V supply (I/O) / functional ground 500 V AC, 50 Hz, 1 min.
Test voltage: 5 V supply (I/O)/functional ground 500 V AC, 50 Hz, 1 min.

Connection technology
Connection name Inline connector