AXL E IOL AO1 U M12 R - Analog module

2700278

Axioline E IO-Link/analog converter for connecting an analog actuator, 0 V ... 10 V, M12 connectors, angled version

The IO-Link/analog converter is an IO-Link device that converts the IO-Link protocol into analog signals. It therefore enables you to transmit signals to analog actuators via an IO-Link master.

Utilization restriction
EMC note EMC: class A product, see manufacturer's declaration in the download area

Product type Interface converter
Product family Axioline E
Type Stand-Alone
Axioline E
Type Angled
Diagnostics messages Short circuit Message in the diagnostic code (in the IB IL format)
Configuration invalid Message in the diagnostic code (in the IB IL format)
Module faulty Message in the diagnostic code (in the IB IL format)
Insulation characteristics
Pollution degree 2

Supply: IO-Link
Nominal voltage for I/O supply 24 V DC (This supply voltage is provided via the IO-Link interface of the IO-Link master.)
Nominal current for every IO-Link port max. 100 mA
Current consumption typ. 16.5 mA ±15 % (at 24 V DC)
max. 135 mA
Protective circuit Reverse polarity protection
Short-circuit protection
Overload protection

IO-Link
Number of ports 1
Connection method M12 connector, A-coded
Connection technology 3-conductor
Specification V1.1.1
Reverse polarity protection yes
Cycle Time min. 2 ms
Process data update 2 ms
Amount of process data 16 bit (Input data)
16 bit (Output data)

Analog:
Output name Analog output
Connection method M12 connector, A-coded
Connection technology 3-conductor
Number of outputs 1 (voltage)
D/A converter resolution 12 bit
Data formats IB IL, S7-compatible
Voltage output signal 0 V ... 10 V
Load/output load voltage output min. 2 kΩ
Permissible cable length max. 30 m (Shielded cable)

Diagnostic messages
Diagnostics Short circuit
Message Message in the diagnostic code (in the IB IL format)
Diagnostic messages
Diagnostics Configuration invalid
Message Message in the diagnostic code (in the IB IL format)
Diagnostic messages
Diagnostics Module faulty
Message Message in the diagnostic code (in the IB IL format)

Dimensional drawing
Width 16.6 mm
Height 42 mm
Depth 66.5 mm

Ambient conditions
Ambient temperature (operation) -25 °C ... 60 °C
Degree of protection IP65/IP67
Air pressure (operation) 70 kPa ... 106 kPa (up to 3000 m above sea level)
Air pressure (storage/transport) 70 kPa ... 106 kPa (up to 3000 m above sea level)
Ambient temperature (storage/transport) -25 °C ... 85 °C
Permissible humidity (operation) 5 % ... 95 %
Permissible humidity (storage/transport) 5 % ... 95 %

Protection class III (IEC 61140, EN 61140, VDE 0140-1)