RIF-0-RPT-M-24DC/21 - Relay Module

2908327

Preassembled relay module with Push-in connection, consisting of: relay base with ejector and power contact relay. Contact switching type: 1 changeover contact. Input voltage: 24 V DC. Polarity: A1-, A2+

Product type Relay Module
Product family RIFLINE complete
Application Universal
Operating mode 100% operating factor
Mechanical service life approx. 2x 107 cycles
Insulation characteristics
Insulation safe isolation
Insulation characteristics
Insulation safe isolation
Overvoltage category III
Pollution degree 2

Service life electrical see diagram
Maximum power dissipation for nominal condition 0.22 W
Test voltage (Winding/contact) 4 kVrms (50 Hz, 1 min., winding/contact)
Rated insulation voltage 250 V AC
Short-circuit protection device
Current 10 A (RT28-32)
Voltage 500 V (SCPD)
Short-circuit current 1 kA (conditional short-circuit current)

Coil side
Nominal operating voltage UN 24 V DC
Input voltage range 19.2 V DC ... 36 V DC (20 °C)
Input voltage range in reference to UN see diagram
Drive and function monostable
Drive (polarity) polarized
Typical input current at UN 9 mA
Typical response time 5 ms
Typical release time 8 ms
Coil voltage 24 V DC
Protective circuit Freewheeling diode
Operating voltage display Yellow LED

Switching
Contact switching type 1 changeover contact
Type of switch contact Single contact
Contact material AgSnO
Maximum switching voltage 250 V AC/DC
Minimum switching voltage 5 V (100 mA)
Limiting continuous current 6 A
Min. switching current 10 mA (12 V)
Interrupting rating (ohmic load) max. 140 W (24 V DC)
20 W (48 V DC)
18 W (60 V DC)
23 W (110 V DC)
40 W (220 V DC)
1500 VA (250 V AC)
Utilization category CB Scheme (IEC 60947-5-1) AC15, 3 A/250 V (N/O contact)
AC15, 1 A/250 V (N/C contact)
DC13, 1.5 A/24 V (N/O contact)
DC13, 0.2 A/110 V (N/O contact)
DC13, 0.1 A/220 V (N/O contact)

Connection method Push-in connection
Stripping length 8 mm
Conductor cross section rigid 0.14 mm² ... 1.5 mm²
Conductor cross section flexible 0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (Ferrule with plastic sleeve)
Conductor cross section AWG 24 ... 16

Width 6.2 mm
Height 92.5 mm
Depth 77.7 mm

Color gray (RAL 7042)
Flammability rating according to UL 94 V2 (Housing)
Housing material PA

Ambient conditions
Degree of protection (Relay base) IP20 (Relay base)
Degree of protection (Relay) RT III (Relay)
Ambient temperature (operation) -40 °C ... 60 °C
Ambient temperature (storage/transport) -40 °C ... 85 °C

UKCA
Certificate UKCA-compliant
Corrosive gas test
Identification ISA-S71.04. G3 Harsh Group
EN 60068-2-60

Standards/regulations IEC 60947-5-1