SACC-M12FS-5CON-PG11 SH - Connector

1417877

Connector, 5-position, shielded, Socket straight M12, coding: A, Screw connection, knurl material: Zinc die-cast, nickel-plated, cable gland Pg11, external cable diameter 8 mm ... 10 mm

Assembly note NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Product type Circular connector (cable-side)
Number of positions 5
No. of cable outlets 1
Shielded yes
Coding A
Cable outlet straight
Pg screw connection Pg11
Insulation characteristics
Overvoltage category II
Degree of pollution 3

Dimensional drawing
Length 57 mm
Wrench size, union nut 16 mm
External dimensions
Outside diameter 8 mm ... 10 mm
Housing
Diameter housing 20.2 mm

Flammability rating according to UL 94 HB
Seal material NBR
Material of grip body Zinc die-cast, nickel-plated
Contact material CuZn
Contact surface material Au
Contact carrier material PA
Material for screw connection Zinc die-cast, nickel-plated

Conductor connection
Connection method Screw connection
Connection cross section 0.25 mm² ... 0.75 mm² (without ferrule)
0.14 mm² ... 0.75 mm² (with ferrule)
0.25 mm² ... 0.75 mm² (solid)
Connection cross section AWG 24 ... 18 (without ferrule)
26 ... 20 (with ferrule)
Stripping length of the individual wire 5 mm
Tightening torque 0.4 Nm (M12 knurl)
0.2 Nm (Screw terminal blocks)
1 Nm ... 1.4 Nm (Pressure nut with 8 mm ... 12 mm external cable diameter)

Rated surge voltage 1.5 kV
Contact resistance ≤ 3 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 4 A

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Socket
Head cable outlet straight
Head thread type M12
Coding A

Stripping length of the individual wire 5 mm

Ambient conditions
Degree of protection IP67
Ambient temperature (operation) -40 °C ... 85 °C (Plug / socket)

Standard designation M12 connector
Standards/specifications IEC 61076-2-101