SACC-M12FRS-2PECON-PG 9-M - Power connector

1419642

Power connector, 3-position, Socket angled M12, coding: S, Screw connection, knurl material: Zinc die-cast, nickel-plated, cable gland Pg9, external cable diameter 6 mm ... 8 mm, for alternating current up to 16 A/630 V

General Strip 21 mm off the cable sheath, strip 6 mm off the conductor insulation, crimp the ferrule, then shorten this to 5 mm. Conductor length with shortened ferrule: 20 mm. Connect conductors and tighten the mounting screws with 0.2 Nm.
Assembly note NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Assembly note The connector pin assignment can be rotated 90° to the cable outlet

Product type Circular connector (cable-side)
Application Power supply
Number of positions 3
No. of cable outlets 1
Shielded no
Coding S
Cable outlet angled
Pg screw connection Pg9
Insulation characteristics
Overvoltage category III
Degree of pollution 3

Dimensional drawing
Length 35 mm
Wrench size, union nut 16 mm
External dimensions
Outside diameter 6 mm ... 8 mm
Housing
Diameter housing 20 mm

Flammability rating according to UL 94 V0
Seal material Viton
NBR
Material of grip body PA
Contact material CuZn
Contact surface material Au
Contact carrier material PA
Material for screw connection Zinc die-cast, nickel-plated

Conductor connection
Connection method Screw connection
Connection cross section 0.75 mm² ... 1.5 mm² (with ferrule)
0.75 mm² ... 2.5 mm² (solid)
Connection cross section AWG 18 ... 16 (with ferrule)
Stripping length of the individual wire 5 mm
Tightening torque 0.4 Nm (M12 knurl)
0.8 Nm ... 1 Nm (Pressure screw with sleeve housing)
0.4 Nm (Screw plug insert with sleeve housing as far it will go)
0.2 Nm (Screw terminal blocks)

Rated surge voltage 6 kV
Contact resistance ≤ 5 mΩ
Insulation resistance > 10 GΩ
Nominal voltage UN 630 V AC
Nominal current IN 16 A (when using 2.5 mm² conductors)
16 A (at 40 °C)

Mechanical data
Insertion/withdrawal cycles > 100

Connection 1
Head design Socket
Head cable outlet angled
Head thread type M12
Coding S

Stripping length of the individual wire 5 mm

Ambient conditions
Degree of protection IP67
Ambient temperature (operation) -40 °C ... 85 °C (Plug / socket)

Standard designation M12 connector
Standards/specifications IEC 61076-2-111