MINI MCR-2-RPS-I-I-OLP - Repeater power supply

2906446

1-channel output loop-powered 2-way repeater power supply with plug-in connection technology for the electrical isolation of analog signals. Input signal = output signal: 0(4) mA ... 20 mA. Screw connection technology.

Single-channel output loop-powered 2-way repeater power supply with plug-in connection technology for the electrical isolation and filtering of analog signals. The output loop-powered isolator enables operation at an active analog input card with a supply voltage of 6 V DC ... 30 V DC. The isolator and the connected sensors are supplied via the current loop of the controller. Input signal = output signal: 0(4) mA to 20 mA. The measuring transducer supports NFC communication.

Utilization restriction
EMC note EMC: class A product, see manufacturer's declaration in the download area

Product type Repeater power supplies
Product family MINI Analog Pro
No. of channels 1
Type Signal conditioner
Insulation characteristics: GB Standard
Overvoltage category II
Pollution degree 2

Electrical isolation 2-way isolation
Electrical isolation between input and output yes
Limit frequency (3 dB) 100 Hz
Signal transmission behavior In = Out
Maximum temperature coefficient ≤ 0.001 %/K
Maximum transmission error ≤ 0.1 % (At 5 V)
Electrical isolation Input/output/power supply
Rated insulation voltage 300 Vrms
Test voltage 3 kV AC (50 Hz, 60 s)
Insulation Reinforced insulation according to IEC/EN 61010-1
Supply
Supply voltage range 8 V DC ... 30 V DC (loop-powered, no external supply necessary)
Power consumption 600 mW (25 mA)

Signal: Current
Number of inputs 1
Configurable/programmable no
Current input signal 0 mA ... 20 mA
4 mA ... 20 mA
Voltage dissipation 3.1 V (I = 20 mA)
Transmitter supply voltage UA - 5 V
Additional error, depending on the input voltage (UA - 5 V) x 0.06 %

Signal: Current
Number of outputs 1
Configurable/programmable no
Current output signal 0 mA ... 20 mA
4 mA ... 20 mA
Response current  200 µA
Voltage dissipation 3.1 V (I = 20 mA)
Load/output load current output 600 Ω

Connection method Screw connection
Stripping length 10 mm
Screw thread M3
Conductor cross section rigid 0.2 mm² ... 1.5 mm² (with ferrule)
0.14 mm² ... 2.5 mm² (without ferrule)
Conductor cross section flexible 0.14 mm² ... 2.5 mm²
Conductor cross section AWG 24 ... 12 (flexible)
Tightening torque 0.5 Nm ... 0.6 Nm

Ex installation (EPL) Gc
Div. 2

Width 6.2 mm
Height 109.81 mm
Depth 119.2 mm

Color gray (RAL 7042)
Housing material PBT
Fire protection for rail vehicles (DIN EN 45545-2) R22 HL 1 - HL 2
Fire protection for rail vehicles (DIN EN 45545-2) R23 HL 1 - HL 2
Fire protection for rail vehicles (DIN EN 45545-2) R24 HL 1 - HL 2

Ambient conditions
Degree of protection IP20 (not assessed by UL)
Ambient temperature (operation) -40 °C ... 70 °C
Ambient temperature (storage/transport) -40 °C ... 85 °C
Altitude ≤ 2000 m
Permissible humidity (operation) 5 % ... 95 % (non-condensing)