IL ETH BK DI8 DO4 2TX-XC-PAC - Bus coupler

2701388

Inline, Bus coupler, Modbus/TCP(UDP), RJ45 jack, Digital inputs: 8, 24 V DC, connection technology: 3-conductor, Digital outputs: 4, 24 V DC, 500 mA, connection technology: 3-conductor, Extreme conditions version, transmission speed in the local bus: 500 kbps / 2 Mbps, degree of protection: IP20, including Inline connectors and marking fields

Width 80 mm
Height 119.8 mm
Depth 71.5 mm
Note on dimensions Specfications with connectors

Modbus/TCP (UDP)
Number of interfaces 2
Connection method RJ45 jack
Note on the connection method Auto negotiation and autocrossing
Transmission speed 10/100 Mbps
Transmission physics Ethernet in RJ45 twisted pair
Inline local bus
Number of interfaces 1
Connection method Inline data jumper
Transmission speed 500 kbps / 2 Mbps (automatic detection, no combined system)
Fieldbus: Local bus gateway
Max. number of local bus devices 61 (The on-board I/Os are two devices)

System limits
Number of supported devices max. 63 (per station)
Number of local bus devices that can be connected max. 61 (The on-board I/Os are two devices)
Number of devices with parameter channel max. 16
Number of supported branch terminals with remote bus branch 0
Module
ID code (hex) none
Input address area 8 bit
Output address area 4 bit
Register length 16 bit

Digital:
Input name Digital inputs
Description of the input EN 61131-2 type 1
Number of inputs 8
Connection method Inline connector
Connection technology 3-conductor
Input voltage 24 V DC
Input voltage range "0" signal -30 V DC ... 5 V DC
Input voltage range "1" signal 15 V DC ... 30 V DC
Nominal input voltage UIN 24 V DC
Nominal input current at UIN typ. 3 mA
Typical input current per channel typ. 3 mA
Typical response time approx. 500 µs
Delay at signal change from 0 to 1 1.2 ms
Delay at signal change from 1 to 0 1.2 ms
Protective circuit Reverse polarity protection; Suppressor diode

Digital:
Output name Digital outputs
Connection method Inline connector
Connection technology 3-conductor
Number of outputs 4
Protective circuit Short-circuit and overload protection; Freewheeling circuit in the output driver
Output voltage 24 V DC -1 V (At nominal current)
Maximum output current per module max. 2 A
Nominal output voltage 24 V DC
Output current when switched off max. 10 µA (When not loaded, a voltage can be measured even at an output that is not set.)
Nominal load, inductive 12 VA (1.2 H, 48 Ω)
Nominal load, lamp 12 W
Nominal load, ohmic 12 W
Reverse voltage resistance to short pulses Reverse voltage proof
Behavior with overload Auto restart
Behavior with inductive overload Output can be destroyed
Behavior at voltage switch-off The output follows the power supply without delay
Signal delay typ. 1.2 ms
Overcurrent shut-down min. 0.7 A

Product type I/O component
Product family Inline
Type modular
Scope of delivery including Inline connectors and marking fields
No. of channels 12
Special properties Extreme conditions version
Diagnostics messages Short-circuit or overload of the digital outputs yes
Sensor supply failure yes
Failure of the actuator supply yes