PLC-OPT- 24DC/ 5DC/100KHZ-G - Solid-state relay module

2902972

Input solid-state relay, with DC voltage output push-pull, transmission frequency: 100 kHz, with light indicator and protective circuit in input and output circuits, input: 24 V DC, output: 4 - 18 V DC/50 mA

Product type Solid-state relay module
Product family PLC-INTERFACE
Application 100 kHz input optocoupler
Operating mode 100% operating factor
Insulation characteristics
Insulation Basic insulation
Insulation characteristics: Air clearances and creepage distances between the power circuits
Insulation Basic insulation
Overvoltage category II
Pollution degree 2

Maximum power dissipation for nominal condition 0.19 W
Test voltage (Input/output) 2.5 kVrms (50 Hz, 1 min., input/output)
Air clearances and creepage distances between the power circuits
Rated insulation voltage 50 V DC
Rated surge voltage 0.5 kV

Nominal input voltage UN 24 V DC
Input voltage range in reference to UN 0.8 ... 1.2
Input voltage range 19.2 V DC ... 28.8 V DC
Switching threshold "0" signal in reference to UN < 0.4
Switching threshold "1" signal in reference to UN > 0.8
Typical input current at UN 8 mA
Typical response time 1 µs
Typical turn-off time 2 µs
Operating voltage display Yellow LED
Protective circuit Reverse polarity protection
Surge protection
Surge voltage protection > 33 V
Transmission frequency 100 kHz

Designation Output data
Contact switching type 1 N/O contact
Design of digital output electronic
Output voltage range 4 V DC ... 18 V DC
Limiting continuous current 50 mA
Quiescent current 8.5 mA
Surge voltage protection > 35 V
Voltage drop at max. limiting continuous current < 1.2 V
Output circuit 3-conductor push-pull, ground referenced
Protective circuit Reverse polarity protection
Surge protection

Connection method Push-in connection
Stripping length 10 mm
Conductor cross section rigid 0.14 mm² ... 2.5 mm²
Conductor cross section flexible 0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1 mm² (TWIN ferrule)
Conductor cross section AWG 26 ... 14

Width 6.2 mm
Height 80 mm
Depth 95 mm

Color gray (RAL 7042)

Ambient conditions
Degree of protection IP20
Ambient temperature (operation) -20 °C ... 60 °C
Ambient temperature (storage/transport) -25 °C ... 75 °C

Corrosive gas test
Identification ISA-S71.04. G3 Harsh Group
EN 60068-2-60

Air clearances and creepage distances between the power circuits
Standards/regulations IEC 60947-5-1

Mounting type DIN rail mounting
Assembly note in rows with zero spacing
Mounting position any