SACC-DSI-MS-17CON-L180 SCO SH - Device connector rear mounting

1436819

Device connector rear mounting, 17-position, Pin, straight, M12-SPEEDCON, coding: A, Rear mounting, Pg9, Solder pins, Alternative product in accordance with RoHS II without Exemption 6c (Pb < 0.1 %) item no.: 1239636

Notes on operation The electrical and mechanical data specified assume that the connector pair is correctly locked and mounted. If the connector is unlocked and if there is a danger of contamination, the connector must be sealed using a protective cap > IP54. Influences arising from litz wires, cables or PCB assembly must also be taken into consideration.
Order information: Lock nut is included in the scope of delivery

Mounting type Rear mounting Pg9 With flat nut
Assembly note With flat nut

Product type Circular connectors (device side)
Number of positions 17
Shielded yes
Coding A
Thread type M12
Insulation characteristics
Overvoltage category II
Degree of pollution 3

Length of the solder pin 6 mm
6 mm

Flammability rating according to UL 94 V0
Seal material NBR
Contact material CuZn
Contact surface material Au
Contact carrier material PA 6.6
Material for screw connection Zinc die-cast, nickel-plated

Rated surge voltage 0.8 kV
Contact resistance ≤ 3 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 30 V
Nominal current IN 1.5 A

Conductor connection
Connection method Solder pins
Contact connection type Pin
Tightening torque 2 Nm ... 3 Nm (Installation-side)

Mechanical data
Insertion/withdrawal cycles > 100

Connection 1
Head design Pin
Head cable outlet straight
Head thread type M12
Head locking type SPEEDCON
Coding A

Ambient temperature (operation) -40 °C ... 85 °C (cable, fixed installation)
-25 °C ... 85 °C (Cable, flexible installation)

Ambient conditions
Degree of protection IP67 (When plugged in)
IP65 (When plugged in)
IP65/IP67
Ambient temperature (operation) -25 °C ... 85 °C (Plug / socket)
-40 °C ... 85 °C (without mechanical actuation)
-25 °C ... 85 °C (Cable, flexible installation)
-40 °C ... 85 °C (cable, fixed installation)

M12
Standard designation M12 connector
Standards/specifications IEC 61076-2-101