IB IL 24 PSDO 4/4-PAC - Safety module

2916493

Safety digital output module, IP20 degree of protection, for the SafetyBridge-, INTERBUS-Safety- and the PROFIsafe system. It has four safe digital outputs which include one positive and one negative switching output each depending on the parameterization.

The safety module is an output module from the Inline product range designed for use at any point within a SafetyBridge, INTERBUS-Safety or PROFIsafe system. The transmission speed of the safety module can be set to 500 kBaud or 2 Mbaud using a switch. One transmission speed must be used consistently within a station. The module has four safe digital outputs for two-channel assignment or four digital outputs for single-channel assignment.

Dimensional drawing
Width 48.8 mm
Height 119.8 mm
Depth 71.5 mm
Note on dimensions Housing dimensions

Inline local bus
No. of channels 2
Connection method Inline data jumper
Transmission speed 500 kbps / 2 Mbps (can be switched)

Module
ID code (dec.) 167
ID code (hex) A7
Length code (hex) 04
Length code (dec) 04
Process data channel 8 Byte
Input address area 8 Byte ((Operating mode: SafetyBridge))
Output address area 8 Byte ((Operating mode: SafetyBridge))
Register length 8 Byte
Required parameter data 1 Byte ((Operating mode: SafetyBridge))
Required configuration data 5 Byte ((Operating mode: SafetyBridge))

Digital:
Output name Digital outputs
Output description +/- switching
Connection method Spring-cage connection
Connection technology 2-, 3-conductor
Number of outputs 4 (for 2-channel assignment, +/- switching)
4 (for 1-channel assignment, + switching)
4
Protective circuit Overload protection, short-circuit protection of outputs
Output voltage 24 V DC (US - 1 V)
Output current max. 3 A (Total current of all outputs)
Maximum output current per channel 2 A
Maximum output current per module 3 A (See technical data)
Nominal output voltage 24 V DC
Behavior with inductive overload Output can be destroyed

Product type I/O component
Product family Inline
Application Functional safety
Type modular
Diagnostics messages Short-circuit or overload of the digital outputs Error message in diagnostics code (bus) and display by means of the LED on the motor

Maximum power dissipation for nominal condition 78 W
Transmission medium Copper
Potentials: Communications power (UL)
Supply voltage 7.5 V DC (see safety data)
Current draw max. 230 mA
Potentials: Main circuit supply (UM)
Supply voltage 24 V DC
Supply voltage range 19.2 V DC ... 30 V DC (including all tolerances, including ripple)
Current draw max. 3.03 A
typ. 30 mA (all outputs set including actuator current)
Potentials: Segment circuit supply (US)
Supply voltage 24 V
Supply: Module electronics
Supply voltage 24 V DC (via voltage jumper)
Supply voltage range 19.2 V DC ... 30 V DC
Electrical isolation/isolation of the voltage ranges
Test voltage: 5 V supply, incoming remote bus/7.5 V supply (bus logics) 500 V AC, 50 Hz, 1 min.
Test voltage: 5 V supply, outgoing remote bus/7.5 V supply (bus logics) 500 V AC, 50 Hz, 1 min.