SACC-M12FR-12SOL-PG 9-M - Connector

1404423

Connector, Universal, 12-position, Socket angled M12, coding: A, Solder connection, knurl material: Zinc die-cast, nickel-plated, cable gland Pg9, external cable diameter 6 mm ... 8 mm

Assembly note NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Assembly note The connector pin assignment can be rotated 90° to the cable outlet

Product type Circular connector (cable-side)
Sensor type Universal
Number of positions 12
No. of cable outlets 1
Shielded no
Coding A
Cable outlet angled
Pg screw connection Pg9
Insulation characteristics
Overvoltage category II
Degree of pollution 3

Dimensional drawing
Width 20.2 mm
Height 42 mm
Length 38 mm
External dimensions
Outside diameter 6 mm ... 8 mm
Housing
Diameter housing 20.2 mm

Flammability rating according to UL 94 HB
Seal material NBR
Material of grip body PA
Contact material CuZn
Contact surface material Au
Contact carrier material PA
Material for screw connection Zinc die-cast, nickel-plated

Conductor connection
Connection method Solder connection
Connection cross section 0.08 mm² ... 0.25 mm² (without ferrule)
0.08 mm² ... 0.25 mm² (solid)
Connection cross section AWG 28 ... 24 (without ferrule)
Stripping length of the individual wire 4 mm
Tightening torque 0.4 Nm (M12 knurl)
0.8 Nm ... 1 Nm (Pressure nut with coupling sleeve)

Rated surge voltage 0.5 kV
Contact resistance ≤ 3 mΩ
Insulation resistance > 10 GΩ
Nominal voltage UN 30 V AC
30 V DC
Nominal current IN 1.5 A (up to 40 °C)

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Socket
Head cable outlet angled
Head thread type M12
Coding A

Signal type/category Universal
Stripping length of the individual wire 4 mm