SACC-M12FS-5PL - Connector

1424689

Connector, Universal, 5-position, unshielded, Socket straight M12, coding: A, Push-lock spring connection, knurl material: Plastic, external cable diameter 4 mm ... 8 mm

Assembly note NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Assembly note The wires can be connected both with ferrules and without ferrules

Product type Circular connector (cable-side)
Sensor type Universal
Number of positions 5
No. of cable outlets 1
Shielded no
Coding A
Cable outlet straight
Insulation characteristics
Overvoltage category II
Degree of pollution 3

Dimensional drawing
Length 58 mm
External dimensions
Outside diameter 4 mm ... 8 mm
Housing
Diameter housing 19 mm

Flammability rating according to UL 94 V0
Seal material NBR
Material of grip body PA 6.6
Contact material CuSn
Contact surface material Ni/Au
Contact carrier material PA 6.6
Material for screw connection Plastic

Conductor connection
Connection method Push-lock spring connection
Connection cross section 0.14 mm² ... 0.75 mm² (without ferrule)
0.08 mm² ... 0.5 mm² (with ferrule)
0.14 mm² ... 0.75 mm² (solid)
Connection cross section AWG 26 ... 18 (without ferrule)
28 ... 20 (with ferrule)
Stripping length of the individual wire 7 mm
Tightening torque 0.4 Nm (M12 knurl)
0.4 Nm (Connector with coupling sleeve)
1.5 Nm (Pressure nut with coupling sleeve)
Pin assignment
Contact | Color (signal designation) | Contact (optional) 1 = BN
2 = WH
3 = BU
4 = BK
5 = GY

Rated surge voltage 1.5 kV
Contact resistance ≤ 5 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 4 A (2 A when using 0.14 mm² conductors)

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Socket
Head cable outlet straight
Head thread type M12
Coding A