IB IL SGI 2/P/EF-PAC - Analog module

2702373

Inline, Strain gauge measurement terminal, transmission speed in the local bus: 500 kbps, 2 precise and fast inputs, 4-, 6-conductor connection technology, degree of protection: IP20, including Inline connectors and marking fields

The terminal is designed for use within an Inline station. This terminal is a precise and fast input module. It is designed to connect load cells, force transducers, mass pressure transducers, and similar devices. The terminal is based on strain gauges. You can connect the strain gauges using 6- or 4-conductor technology. The measured value can be output directly on a weight display via a serial interface. There are two options for data exchange: - via process data - via PCP Compact (both inputs in the “Analog Values” PCP object) The measured values are represented by standardized 16-bit values.

Dimensional drawing
Width 48.8 mm
Height 136 mm
Depth 71.5 mm

Inline local bus
Connection method Inline data jumper
Transmission speed 500 kbps
Transmission physics Copper
Serial
Designation V.24 (RS-485) serial interface
Addressing Address 1 = Measured gross/net value
Address 2 = Measured tare value
Termination resistor 120 Ω
Transmission protocol STX/ETX

Module
ID code (dec.) 223
ID code (hex) DF
Length code (hex) 03
Length code (dec) 03
Process data channel 48 bit
Input address area 6 Byte
Output address area 6 Byte
Register length 64 bit
Required parameter data 23 Byte
Required configuration data 5 Byte

Analog
Description of the input Input channels for strain gauge
Number of inputs 2
Connection technology 6 or 4-wire, twisted pair shielded cable
Bridge difference Ud Measuring range specified by selecting the characteristic
Bridge voltage U0 5 V
Measured value representation 16 bit, 20 bit, ASCII data record
Characteristics ±1 mV/V, ±2 mV/V, ±3 mV/V, ±3.33 mV/V, ±4 mV/V, ±5 mV/V, ±6 mV/V, manual characteristic value specification
Contacts
Description Floating N/O contact
Quantity 2 (Ka1-Kb1, Ka2-Kb2)
Contact resistance < 1 Ω (typical)
3 Ω (maximum)
Typical response time typ. 0.2 ms (opening)
typ. 2 ms (close)

Analog
Output description Jumper supply
Number of outputs 2
Impedance > 43 Ω (per channel)
Output voltage typ. 5 V
Output current max. 115 mA (per channel)

Product type I/O component
Product family Inline
Type modular
Scope of delivery including Inline connectors and marking fields
Operating mode Process data operation with 3 words, PCP with 1 word
Special properties 2 precise and fast inputs
4-, 6-conductor connection technology
Diagnostics messages Failure of the power supply at UANA Error message in the process data
Failure of or insufficient communications power UL I/O error message sent to the bus coupler
I/O error Error message in the process data