PLC-OPT- 24DC/ 48DC/500/W - Solid-state relay module

2900378

PLC-INTERFACE with electronic changeover contact, consisting of PLC-BPT…/21 basic terminal block with Push-in connection and integrated miniature solid-state relay, for mounting on DIN rail NS 35/7,5, 1 changeover contact, input: 24 V DC, output: 3-48 V DC/500 mA

Product type Solid-state relay module
Product family PLC-INTERFACE
Application With integrated solid-state relay
Operating mode 100% operating factor
Insulation characteristics
Insulation Basic insulation
Insulation characteristics: Standards/regulations
Insulation Basic insulation
Overvoltage category III
Pollution degree 2

Maximum power dissipation for nominal condition 0.07 W
Standards/regulations
Rated insulation voltage 300 V
Rated surge voltage 4 kV

Nominal input voltage UN 24 V DC
Input voltage range in reference to UN 0.8 ... 1.2
Input voltage range 19.2 V DC ... 28.8 V DC
Switching threshold "0" signal in reference to UN ≤ 0.4
Switching threshold "1" signal in reference to UN ≥ 0.8
Typical input current at UN 3 mA
Typical response time 0.03 ms
Typical turn-off time 0.15 ms
Operating voltage display Yellow LED
Protective circuit Reverse polarity protection; Polarity protection diode
Surge protection
Transmission frequency 1000 Hz

Contact switching type 1 changeover contact
Design of digital output electronic
Contact connection type Power contact
Output voltage range 3 V DC ... 48 V DC
Limiting continuous current 500 mA (see derating curve)
Min. load current 1 mA
Voltage drop at max. limiting continuous current < 1.2 V
Output circuit 2-conductor, floating
Protective circuit Reverse polarity protection; Polarity protection diode
Surge protection

Connection method Push-in connection
Stripping length 10 mm
Conductor cross section rigid 0.14 mm² ... 2.5 mm²
Conductor cross section flexible 0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1 mm² (TWIN ferrule)
Conductor cross section AWG 26 ... 14

Width 6.2 mm
Height 80 mm
Depth 95 mm

Color gray (RAL 7042)
Flammability rating according to UL 94 V0 (Housing)

Ambient conditions
Ambient temperature (operation) -25 °C ... 60 °C
Ambient temperature (storage/transport) -40 °C ... 85 °C

Corrosive gas test
Identification ISA-S71.04. G3 Harsh Group
EN 60068-2-60

Standards/regulations
Standards/regulations IEC 60664
EN 50178