SACC-M12MS-5CT-CM SH - Connector

1422850

Connector, Universal, 5-position, shielded, Plug straight M12, coding: A, Crimp connection, knurl material: Zinc die-cast, tin-plated, external cable diameter 4.5 mm ... 7.5 mm, without crimp contacts

Assembly note NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.

Assembly note Contacts can be clipped in place and unclipped without tools

Product type Circular connector (cable-side)
Sensor type Universal
Number of positions 5
No. of cable outlets 1
Shielded yes
Coding A
Cable outlet straight
Insulation characteristics
Overvoltage category III
Degree of pollution 3

Dimensional drawing
Length 43 mm
Wrench size, union nut 15 mm
Wrench size, counter nut 14 mm
External dimensions
Outside diameter 4.5 mm ... 7.5 mm
Housing
Diameter housing 16 mm

Flammability rating according to UL 94 V0
Seal material FKM
Material of grip body Zinc die-cast, nickel-plated
Contact carrier material PA 6.6
Material for screw connection Zinc die-cast, tin-plated
Standards/regulations PA 6.6: Fire protection in rail vehicles - requirement sets R22, R23, R24, and R26 acc. to DIN EN 45545-2 (Risk level HL1 - HL3)

Conductor connection
Connection method Crimp connection
Connection cross section 0.14 mm² ... 1 mm² (flexible)
Connection cross section AWG 26 ... 18 (flexible)
Stripping length of the individual wire 4 mm +0,5 mm
Tightening torque 0.4 Nm (M12 knurl)
4 Nm (Pressure nut with coupling sleeve)
Pin assignment
Contact | Color (signal designation) | Contact (optional) 1 = BN
2 = WH
3 = BU
4 = BK
5 = GY

Rated surge voltage 1.5 kV
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 48 V AC
60 V DC
Nominal current IN 4 A

Mechanical data
Insertion/withdrawal cycles ≥ 100

Connection 1
Head design Plug
Head cable outlet straight
Head thread type M12
Coding A